Introduction to 3D Scanning Workshop

uOttawa Richard L’Abbé Makerspace | Powered by CEED
Thursday, 24 January 2019 - 12:30 am to 1:30 am
Location
Where: 
STEM Complex, 150 Louis Pasteur Private (map)
Room number: 
STM121
Contact information
Contact person: 
Emilie Salinas
Email: 
esalinas@uottawa.ca
Phone: 
6135625800
Extension: 
3044
Registration
Registration required: 
Yes
Registration website: 
https://www.eventbrite.ca/e/introduction...
Cost to attend: 
Free of charge
Cost details: 
This is a free event
  • This event is offered only in English.
Event type: 
Workshops & seminars, Personal enrichment
Event organizer: 
CEED, Faculty of Engineering, Engineering Entrepreneurship
Event language: 
English
Intended audience: 
Open to all, Students, Undergraduate students, Graduate students, Professors, Staff, Alumni, Public
Supporting website: 
https://engineering.uottawa.ca/ceed/design-spaces/makerspace

In this workshop, you will learn how to operate the NextEngine 3D scanner located in the Makerspace. You will learn how to set up a piece for optimal scanning, as well as how to configure the software in order to achieve the best results. 3D scanners are very effective in the field of reverse engineering and can open up your design possibilities. Please note that this workshop is a demonstration as the scanner takes a fair amount of time to complete scans, therefore we will only be covering its operation.

If you have not already, please make an account on Makerepo.com before coming to the workshop, and bring your student card or any RFID capable card!